Lanotec Timber Seal products are manufacture in Australia, they are environmentally friendly and user safe, solutions to the preservation and protection of natural timbers. Go to the next page for further information and Links
Repels Water
Highlights Natural Grain
Prevents Drying, Splitting & End Grain Swelling
Penetrates and Preserves
Extends timber life
Safe to apply in environmentally sensitive locations
Easy to apply-good coverage
Acid & Salt water resistant
Versatile and Effective
Prevents corrosion of Fastenings
Non-Toxic, Non-Leaching, Non Polluting
APPLICATION
DO NOT apply to “GREEN” Timber
If timber is green apply only to inside joints and on bolts and fastenings. Allow timber to weather further before applying.
High levels of Tannin, Resin, Oils and moisture affect penetration rate of Timber seal.
Previously untreated timber should be cleaned to remove any mould or fungus spores.
Can be used on timber previously oiled - timber should so signs of dryness before using Timber Seal
If timber is grey sand surface or use timber restorer. Clean off before using timber seal.
Use Flat Lambswool applicator, brush or Roller. Underside can be sprayed, preferably prior to construction.
Apply light and sparingly. If you over apply it will end up with a tacky finish.
Timber seal is a preserver it will not prevent greying by leaching of tannins, restore colour with an oil based tint prior to reapplication.
Finish off with polishing/Buffing to remove residue and maximise seal.
Timber seal is NOT compatible with waterbased acrylic coatings.
Drying time 2 to 6 hours between coats.
Clean Up using Citra Force or Mineral turps and warm soapy water.
Lanotec
Lanotec’s lanolin products are environmentally friendly as they are non toxic, non carcinogenic, non-ozone depleting and biodegradable.
Our products are nature’s answers to the problems of the world in the 21st century.
Lanotec’s lanolin products have been tested by independent NATA certified laboratories.
